Reading volume:1 发表时间:2021/5/6 9:00:48
In this issue, the editor will take you to the sprocket manufacturer to understand the installation and adjustment of the machine tool during the production of the sprocket. Let’s learn about it with the editor:
The installation of the tool is actually a very meticulous work. The use of the tool gauge and the control of the pressure gauge value can only be adjusted accurately through the accumulation of practical experience. The rake angle of the tool should be 0*~25” (depending on the material) , The machining steel parts are 20*~25"), the cutting edge bevel angle is 12*, and the tool setting gauge for sharpening is included in the machine tool attachment.Pay attention to the straightness of the cutting edge after the tool is sharpened.
机床主轴孔是莫氏6号锥体,大端尺寸为中63.35mm.心轴装入主轴孔时应轻轻推人,心轴端面与主轴端面间隙为0. 05~0.20mm.
The mandrel should be made consistent with the taper of the main shaft. The contact surface should reach 75% and be close to the big end. When the mandrel is installed, the circular runout of the rear end should not be greater than 0mm, and the radial runout should not be greater than 005mm (cutting 0.01-level gear Time).
In this issue, the editor will introduce these contents for you, remember to follow us to learn more about relevant knowledge.