Reading volume:2 发表时间:2021/3/8 8:37:24
Speaking of gears, everyone is not unfamiliar. In life, you will often see that because the cost of gear processing is relatively low, but the quality requirements in the production process are very high, and it cannot be caused by poor rigidity or other reasons. The phenomenon of deformation and bending occurs. Our factory has been producing gears for many years. The castings produced are higher than other products in all aspects, especially the service life has been extended.
The manufacturer will arrange the scribing process for the gear many times, and it can also balance the machining allowance of each part. It can also ensure the accuracy of the processing and the accuracy of the position; at the same time, it has modern equipment and technology that can adjust the gear. Quality treatment. The processed large gear ring will have good comprehensive mechanical properties.
Improve gear processing technology:
The machining process will have a great influence on the error, so it is necessary to improve the process to improve the accuracy of the gear.
Make sure that the axis of the worktable and the center axis of the fixture can be completely overlapped. Do the corresponding inspection work before installing the tool. Then clean the end face and the inner hole of the tool, and slowly push the blade into the handle. Do not use heavy objects. Hammer the handle.