Reading volume:15 发表时间:2019/4/17 9:23:32
In this issue, the editor will give you a detailed description of the processing design of gears. If you want to know, please come and learn about it together
First of all, generally speaking, the design of the gear shaft is a pinion gear, and the larger feature of this kind of gear is that the number of teeth on the gear is relatively small.If it is a high-speed gear, it is also a low-torque gear.In some special occasions, variable-speed sliding gears are also used. This kind of gear processing is rarely used, because if it is in the high-speed situation, the sliding variable-speed gears simply cannot cope with it.When designing, the general designer will try to shorten the length of the shaft as much as possible, because if the shaft length is too long, the difficulty of processing on the hobbing machine will also increase.And because the length is too long, the strength of the parts will also be adversely affected.
Introduction of helical gear processing method:
The involute helical gear reducer for helical gear processing is relatively small in size, light in weight, efficient in use, and has a relatively high load-bearing capacity. The service life is relatively long, and the installation process is convenient. The power range of the configured motor is relatively wide, and the transmission ratio is a hierarchical method, which is very fine and can be widely used in deceleration equipment in various industries.
The editor of the above content is here for everyone. Pay attention to this website for more relevant information.If you need help, please call directly.