Sprockets are widely used in today's life. Where are they used?Let's get to know some relevant knowledge with the editor below.Sprockets are widely used in the transmission system of various vehicles and mechanical equipment. The sprocket satisfies...
If we want a product that can be used for a long time, then we need to maintain and maintain it on weekdays. Therefore, how to extend the service life of the sprocket?The specific introduction is as follows: 1. The tightness of the sprocket should be suitable. Too tight will increase a work...
Speaking of gears, everyone is not unfamiliar with them. Do you know its function and structure?Let's take a look at it together. The specific introduction is as follows: Gear is an important transmission part of the machine.Its main function is to use flat keys or flowers...
According to the hardness, the tooth surface can be divided into two types: soft tooth surface and hard tooth surface.The load-carrying capacity of gears with soft tooth surfaces is relatively low, but they are relatively easy to manufacture. They have good running fit and are mostly used for transmission size. There is no strict limit on the size and weight, and small...
Do you know the characteristics of large-pitch sprocket?Do you know its model?The following editor will give you a brief introduction: the large-pitch sprocket is actually a chain drive, and the gear is driven by the tooth. The international measurement unit is different. The sprocket...
Tooth line modification is to avoid excessive load on the root of the tooth line due to a certain tooth problem. Various problems may occur for each tooth, such as errors in gears, shafts or bearings. Errors in assembly, shaft or gear...
Do you know how to choose the right sprocket?With this question, let’s walk into the manufacturer to find out: 1. Choose the correct sprocket model and material according to the model or model. 2. Check whether the parts of the sprocket are intact...
There are many sprocket manufacturers, and I dare not say that our product is Nanbowan, but our factory is very strict in terms of quality, and what we are striving for is product quality and service. 1. The sprocket should be installed on the shaft without skew or swing.Two in the same transmission assembly...